Custom Kitesurfing
Kite Graphics & Decals
Lightweight, durable Dacron stickers built for kite fabric — block colour or full colour printed, shipped worldwide.
Shop All Kite Graphics →Make your kite unmistakable on the water. We produce custom block colour and full colour printed graphics for kitesurfing kites — lightweight, durable, and designed to bond permanently to kite fabric. The finished result is clean and striking both on the beach and in the air, sitting flush with the canopy and remaining bold and visible at speed.
Why Dacron — Not Vinyl?
Standard vinyl stickers are not designed for kite canopy material. Our graphics are produced on 262 GSM self-adhesive Dacron — a pressure-sensitive fabric material specifically compatible with the woven and ripstop fabrics used in kitesurfing kites.
- Fabric-based — moves with the kite rather than against it
- Strong and durable in UV, salt water, and varying temperatures
- Resistant to peeling when applied correctly
- Tested on real kitesurfing equipment
Choose Your Finish
We offer three options depending on your design and budget:
Block Colour Cut
Precision cut from solid-colour Dacron. Sharp, clean edges. Ideal for bold lettering, logos, and striking single-colour designs.
View listing →Full Colour Printed
Photographic-quality print onto white printable Dacron. Perfect for complex logos, gradients, or multi-colour designs.
View listing →Not Sure?
Block colour is sharper and more cost-effective for simple shapes. Full colour suits detailed or multi-colour artwork. Get in touch and we'll advise.
Ask us →Available block colours:
Size & Specifications
| Material weight | 262 GSM |
| Maximum width | Just under 1.3 metres |
| Length | Any — custom cut to your design |
| Shapes | Custom shapes available |
| Min. letter / logo height | 6cm — ideally 10cm or more |
Bold, simple shapes bond better than fine detail or very small cut sections.
Application Instructions
This is a pressure-sensitive adhesive material — not applied like standard vinyl stickers. Correct application is essential for a lasting bond.
Remove all salt, sand, wax, oils, and sun cream residue. The surface must be completely clean and dry before application.
Firm, even pressure is essential to activate the adhesive and bond the material to the kite fabric.
Minimum 24 hours — ideally 48 hours before flying. This allows the adhesive to fully bond.
Gentle heat can help further activate the adhesive, particularly in colder conditions.
Print & Artwork
Every order is produced to your specification. Vector files are preferred (AI, EPS, or SVG) for the sharpest results. If you don't have a vector file, we can help — just get in touch before ordering.
A proof will always be sent for approval before anything goes to print.
Worldwide Shipping
Graphics are dispatched flat and ready to apply. We ship internationally — no installer required.
Also Available For
This same specialist Dacron material is the industry standard across the wider watersports and aerial sports world — used for wing foil graphics, paraglider and paramotor wing stickers, and windsurf sail numbers where fabric-compatible adhesive is essential.
Ready to Order?
Browse all kitesurfing graphics, or get in touch if you're unsure on sizing, colour, or which finish is right for your design.
Shop All Kite Graphics Get in Touch →