Custom Paraglider & Paramotor
Wing Graphics
Lightweight, durable Dacron stickers built for canopy fabric — block colour or full colour printed, shipped worldwide.
Shop the Listing →Make your wing unmistakable in the air. We produce custom block colour and full colour printed graphics for paragliders and paramotor wings — lightweight, durable, and designed to bond permanently to canopy fabric. The finished result is clean and striking both on the ground and in the air, sitting flush with the canopy and remaining bold and visible at altitude.
Why Dacron — Not Vinyl?
Standard vinyl stickers are not designed for paraglider canopy material. Our graphics are produced on 262 GSM self-adhesive Dacron — a pressure-sensitive fabric material specifically compatible with the woven fabrics used in paraglider and paramotor wings.
- Fabric-based — moves with the canopy rather than against it
- Strong and durable in UV, wind, and varying temperatures
- Resistant to peeling when applied correctly
- Tested on real paraglider and paramotor equipment
Block Colour or Full Colour Printed?
Block Colour
Precision cut from solid-colour Dacron. Sharp, clean edges. Ideal for bold lettering, logos, and striking designs.
Full Colour Printed
Photographic-quality print onto white printable Dacron. Perfect for complex logos, gradients, or multi-colour designs. View listing →
If you're unsure which option suits your design, just get in touch and we'll advise.
Available block colours:
Size & Specifications
| Material weight | 262 GSM |
| Maximum width | Just under 1.3 metres |
| Length | Any — custom cut to your design |
| Shapes | Custom shapes available |
| Min. letter / logo height | 6cm — ideally 10cm or more |
Bold, simple shapes bond better than fine detail or very small cut sections.
Application Instructions
This is a pressure-sensitive adhesive material — not applied like standard vinyl stickers. Correct application is essential for a lasting bond.
Remove all salt, dust, oils, and sun cream residue. The surface must be completely clean and dry before application.
Firm, even pressure is essential to activate the adhesive and bond the material to the canopy fabric.
Minimum 24 hours — ideally 48 hours before flying. This allows the adhesive to fully bond.
Gentle heat can help further activate the adhesive, particularly in colder conditions.
Print & Artwork
Every order is produced to your specification. Vector files are preferred (AI, EPS, or SVG) for the sharpest results. If you don't have a vector file, we can help — just get in touch before ordering.
A proof will always be sent for approval before anything goes to print.
Worldwide Shipping
Graphics are dispatched flat and ready to apply. We ship internationally — no installer required.
Also Available For
This same specialist Dacron material is the industry standard across the wider watersports and aerial sports world — used for kitesurfing kite graphics, wing foil stickers, and windsurf sail numbers where fabric-compatible adhesive is essential.
Ready to Order?
Enter your sizing requirements and send your artwork after checkout. Not sure on sizing or colour? Get in touch and we'll advise before you order.
Shop Block Colour Full Colour Printed →
